Publicidad
14. The dimensions for positioning the
cistern button are provided below.
Note that the hole size is
38mm/40mm Diameter.
15. Connect the button by fixing the button to the front face of the unit using the
large outer nut, press slide 'A' to attach the button.
16. Turn on the water after all connections have been made and if necessary
adjust the inlet valve to correct the waterline. This will be pre-set in
assembled units but should be verified by the installer.
17. Place the lid onto the cistern and click side clips in place.
18. Before replacing the access panel into position please ensure the cable is
not restricted or compressed to prevent operation of the button. Also extra
care should be taken to ensure that in narrow units the housing at the rear of
pushbutton fits into the cistern cut outs.
19. Check the button operates the valve correctly and closes when released.
Important Notes
It is the responsibility of the installer to ensure that all joints in the tank are water
tight even on pre-installed units before leaving site.
Never allow the front facia to hang suspended by the cable only this will
affect operation and cause "kinks" in the cable.
10
Cable
135
Button lock
Slide 'A'
Publicidad
