Siefken MAGNUM BRUSHLESS TECH Serie Instrucciones De Uso página 36

3 YEARS
L I M I T E D WA R R A N T Y
TRIGGER SWITCH - FIG. 9
Select the required function.
- Use the forward / reverse switch (3) to adjust the direction of rotation.
- Pull the variable speed trigger (4) to activate the machine.
SDS PLUS + SYSTEM - FIGS. 10 - 11
The tool holder (5.2) holds the drill bits and SDS + chisels without the need for a holding wrench.
- Pull the collar (5.3) back.
- Insert the bit. It may be necessary to rotate the bit to make sure it ts properly.
- Release the collar to lock the bit in place. Check by pulling on the bit to see if it is rmly seated.
Important: always clean and lightly grease the tool shaft before inserting it into the chuck.
Take care that the dust protection cap is not damaged. Allowing dust and debris to enter the media may
cause future problems.
- To remove a little, slide the collar (5.3) towards the back and remove the tool.
Warning: the tip or bit will be hot after use.
14