Troubleshooting; Machine Storage; Service And Repair; Disposal - RIDGID KJ-2200 Manual De Instrucciones

KJ-2200/KJ-3100 Water Jetting Machines

Machine Storage

Store the jetter in a well ventilated area
WARNING
protected from rain and snow. Keep the machine in a
locked area that is out of reach of children and people
unfamiliar with jetters. This machine can cause serious
injury in the hands of untrained users. See Maintenance
section for information on cold weather storage. See
engine operator's manual for specific information on
engine storage.

Service And Repair

WARNING
Improper service or repair can make machine un-
safe to operate.
The "Maintenance Instructions" will take care of most
of the service needs of this machine. Any problems not
addressed by this section should only be handled by
an authorized RIDGID service technician.
Tool should be taken to a RIDGID Independent Author-
ized Service Center or returned to the factory.
For information on your nearest RIDGID Independent
Ser vice Center or any service or repair questions:
• Contact your local RIDGID distributor.
• V isit www.RIDGID.com or www.RIDGID.eu to find
your local RIDGID contact point.
• C ontact RIDGID Technical Services Department at
rtctechservices@emerson.com, or in the U.S. and
Canada call (800) 519-3456.

Troubleshooting

PROBLEM
Jetter runs but produc-
es little or no pressure.
Jetter will not adjust to
full operating pressure
at start-up.
Jetter pressure gage os-
cillates from 500 to full
operating pressure.
18
CAUSE
Inadequate water supply.
Air is trapped in system.
Jetter nozzle thrusters are blocked
Jetter nozzle thrusters are blocked.
Debris or air trapped in system.

Disposal

Parts of the water jetter contain valuable materials and
can be recycled. There are companies that specialize
in recycling that may be found locally. Dispose of the
com ponents in compliance with all applicable regula-
tions. Contact your local waste management authority
for more information.
For EC Countries: Do not dispose of electri-
cal equipment with household waste!
According to the European Guideline 2002/ 96/ EC
for Waste Electrical and Electronic Equipment
and its implemen tation into national legislation,
electrical equipment that is no longer usable must be col-
lected separately and disposed of in an environmentally
correct manner.
Make certain water supply faucet is ON.
Make certain jetter's water supply inlet valve is
ON.
Make certain water supply hose is clear and not
kinked or collapsed.
Remove nozzle from jet hose and run jetter to
flush air/debris from system.
Remove nozzle and clean thruster orifices with
nozzle claning tool.
Remove nozzle. Use nozzle cleaning tool to clear
nozzle orifices: select proper wire size and push
completely through each thruster orifice to re-
move debris.
Remove nozzle and insert jet hose in drain line.
Run jetter to flush trapped air or debris.
CORRECTION