Setting Up The Controls; Release Lever - EMAK MZ2500R Manual De Instrucciones

SETTING UP THE CONTROLS

OPERATING HANDLEBARS
Unscrew knob A (fig. 2) to adjust the
height.
Use lever B (fig. 2) to adjust horizontally.
180° HANDLEBAR ROTATION
Use lever B to rotate the handlebars for use
with front-facing tools. (fig. 3).
Turn the handlebars from right to left in or-
der to avoid damaging the transmission.
To turn the gear lever C (fig. 3) take out the
pin, turn the lever 180° and replace the pin.
When the handlebars are turned, 2nd and
3rd gears are disabled by latch D (fig. 3).
SPIKE
The depth and lateral oscillation of the spike
can be adjusted using screws A (fig. 4).

RELEASE LEVER

Check the release levers regularly. They
must have an idle stroke of 3-4 mm.
To adjust their setting, loosen nut A
(fig. 5) and unscrew or screw down adju-
sting screw B to get the idle stroke required.
Tighten nut B again.
Fig. 2
Fig. 3
Fig. 4
Fig. 5
25