Fender Installing; Wheel Installing With A Standard Fork's End; Wheel Installing With A Qr20 Plus Fork - Marzocchi BOMBER Manual Del Operador

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

Installation
50
3.3

Fender installing

An integrated fender can be installed on
ø32mm-stanchion forks. The fender can be
supplied with the fork or bought separately. The
istallation of the fender (F) must be carried out
as shown in the picture, tightening the bolts (G)
using a 8mm allen key to the required tightening
torque (see Table 1 - Tightening Torques).
3.4
Wheel installing with a
standard fork's end
Install the wheel in compliance with the
manufacturer's instructions.
For correct fork function after wheel installing
you will need to:
• check the correct fork-wheel alignment by
fully compressing the fork a few times.
• lift the front wheel, turn the wheel a few times
to verify the correct alignment with the disk
brake.
3.5
Wheel installing with a QR20
Plus fork
For correct fork function, please follow the
instructions here below when installing the
wheel:
• Release the securing system on both legs by
pushing the levers (A) downwards.
• For quick-release models, open the release
lever (B).
• For threaded cap models, unscrew the cap
(C) as much as needed to insert the wheel
axle through the fork wheel axle clamp.
• Insert the wheel axle (D) through the fork
wheel axle clamp.
• Make sure that the wheel axle supporting nuts
(E) are centered in the sliders' seat
• If the wheel axle is provided with quick-
release system, lock the wheel with the quick-
release lever (B); otherwise, tighten the cap
positioned on the axle side using a 6 mm
Allen key to the required tightening torque
(see Table 1 – Tightening Torques).
• Verify the correct settling of the supporting
nuts (E).
• Check the correct fork-wheel alignment, by
fully compressing the fork a few times.
• Lift the front wheel; turn the wheel a few times
to verify the correct alignment with the disk
brake.
• Lock the securing system by pulling the levers
(A) upwards and adjust clearance through the
adjusters (H), if needed.
G
C
C
F
A
E
B
D
E
A
B
H

Hide quick links:

Publicidad

Tabla de contenido
loading

Tabla de contenido