For Safe Operation - DNP DS-RX1 Guia De Inicio Rapido

For Safe Operation

・ Be sure to read this manual before use. After reading, keep it in a safe place, where it can be re-read as needed.
・ For detailed product explanations, please refer to the User's Manual (on the included CD).
The warnings listed here are to ensure proper use of the device, to prevent physical injury to the customer or other persons, and to
・
prevent property damage. Please obey these warnings.
■ About "Warning" and "Caution"
Listed below, the possible levels of injury or damage due to misuse are categorized as "Warning" and "Caution", according to the degrees
of danger involved.
WARNING
Accidents caused by failure to heed the warnings accompanying this symbol could lead to serious or fatal injury.
CAUTION
Accidents caused by failure to heed the warnings accompanying this symbol could lead to physical injury or property damage.
■ About the symbols
The symbols shown have the following meanings:
This symbol calls attention to contents of warnings and cautions.
Details are indicated in or near this symbol.
This symbol indicates prohibited actions.
Details are indicated in or near this symbol.
This symbol designates necessary actions, and relevant content.
Details are indicated in or near this symbol.
Use only with the designated voltage and frequency. Improper connection could cause electric shock or fire.
・
Avoid overstressing outlets and using extension cords. The outlet could overheat and cause a fire.
・
Do not damage, destroy, bundle, or alter the power cord. Also, placing heavy objects on, pulling on, or
・
bending the cord excessively can damage it, and could cause a fire.
Do not set the printer up in places with salinity or corrosive gases in the air. This could cause a fire.
・
Do not block the vents. Heat could build up in the printer and cause a malfunction or fire.
・
Do not stand on or place heavy objects on the printer. Also, do not use excessive force on the buttons,
・
switches, terminals, etc. This could break the printer and cause injury to the user or others.
Be careful to avoid injury or damages from the edges in the printer.
・
Do not use this printer for applications where malfunction could be life-threatening (such as medical, space,
・
aeronautic, or other applications that require extreme reliability).
The printer weighs approximately 14 kg (31 lbs). When moving it, lift in a way that avoids excessive physicalstress. Lifting recklessly or dropping
・
the printer could cause injury.
Locate the printer as close to an outlet as possible, and allow easy access to unplug the power cord in case ofproblems.
・
If there is dust on the plug, clean it off thoroughly. It could cause electric shock or a short-out.
・
If metal objects or liquids have fallen into the printer, and there is smoke, a strange odor, or any other
・
apparent abnormality, immediately turn the power OFF, and unplug the power cord. Then contact a service
representative. Do not continue using the printer if it is not operating properly. This could cause shock,
short circuit, or fire.
Be sure to attach the ground. Otherwise, it could short-circuit, causing electric shock or fire.
・
Do not plug or unplug the cord with wet hands. This could cause electric shock.
・
Do not open the inside of the printer, disassemble internal parts, or modify the printer. It could cause electric shock, fire, or injury, or break the pri
・
nter. For internal check-ups, adjustments, or repair, please contact a service representative.
Be sure to adhere to the following warnings!
WARNING