Technical Parameters - YATO YT-82281 Manual Del Usuario

PROPERTIES OF THE TOOL
The reciprocating saw is an electric tool designed for cutting of wooden surfaces and surfaces made of wood and those made of
wood derivatives, polyethylene and metals, using adequate blades. Thanks to easy replacement of blades which does not require
additional tools, the saw off ers a wide range of applications in building tasks. A correct, reliable and safe operation of the tool
depends on its correct use, so:
Read the operating manual thoroughly before work and keep it for future reference.
The supplier shall not be held responsible for any damage occurred as a result of failure to observe safety regulations and indica-
tions contained in this manual. Using the tool for purposes it has not been designed for will make the guarantee void and cancel
any rights implied by a breach of contract.
ACCESORIES
The box supplied from the factory contains the following:
- reciprocating saw

TECHNICAL PARAMETERS

Parameter
Catalogue number
Nominal voltage
Nominal frequency
Nominal power
Nominal rotation
Maximum cutting thickness
- wood
- metals
Blade holder
Level of noise:
- acoustic pressure
- power
Vibration (cutting of wood)
Grade of protection
Insulation class
Mass
GENERAL WARNINGS FOR THE SAFETY OF POWER TOOLS
Warning! Read all safety warnings, illustrations and specifi cations provided with this power tool. Failure to do so may
result in electric shock, fi re or serious injury.
Keep all warnings and instructions for future reference.
The term "power tool" used in warnings applies to all tools driven by power both wired and wireless.
Workplace safety
Keep the workplace well-lit and clean. Disorder and poor lighting can be causes of accidents.
Do not work with power tools in an environment with an increased risk of explosion, containing fl ammable liquids, gases
or vapors. Power tools generate sparks that can ignite dust or fumes.
Children and third persons should not be allowed to enter the workplace. Loss of concentration can result in loss of control.
Electrical safety
The plug of the electric cable must match the power socket. You must not modify the plug in any way. Do not use any
plug adapters with earthed power tools. An unmodifi ed plug that fi ts the outlet reduces the risk of electric shock.
Avoid contact with earthed surfaces such as pipes, radiators and coolers. Grounding the body increases the risk of electric shock.
Do not expose power tools to contact with atmospheric precipitation or moisture. Water and moisture that gets inside the
power tool increases the risk of electric shock.
Do not overload the power cable. Do not use the power cord to carry, pull or unplug the power plug from the power outlet.
Avoid contact of the power cable with heat, oils, sharp edges and moving parts. Damage or entanglement of the power cord
increases the risk of electric shock.
O R I G I N A L
GB
Unit of measurement
[V~]
[Hz]
[W]
[min -1 ]
[mm]
[mm]
[dB(A)]
[dB(A)]
[m/s 2 ]
[kg]
I N S T R U C T I O N S
Value
YT-82281
230 - 240
50
1050
0 - 2500
150
10
All-purpose holder 1/2" (12,7 mm)
92,2 ± 3,0
103,2 ± 3,0
25,65 ± 1,5
IPX0
II
3,39
9