Technical Parameters - YATO YT-82170 Manual De Instrucciones

PROPERTIES OF THE PRODUCT
The mitre saw is a versatile tool, designed for cutting wood and wood derivatives. Thanks to a wide scope of adjustments, it is
possible to use the tool for straight and angular cutting. A correct, reliable and safe operation of the tool depends on its correct
use, so:
Read the operating manual thoroughly before work and keep it for future reference.
The supplier shall not be held responsible for any damage occurred as a result of failure to observe safety regulations and indica-
tions contained in this manual.
ACCESSORIES
The box supplied from the factory contains the following:
- mitre saw
- dust bag
- circular saw
- working table supports
- working table clamp
- working table set screw

TECHNICAL PARAMETERS

Parameter
Catalogue number
Nominal voltage
Nominal frequency
Nominal power
Nominal rotation
Maximum cutting height x maximum cutting length
rotating angle at the level of 0 / gradient 0
O
rotating angle at the level of 45 / gradient 0
O
rotating angle at the level of 0 / gradient 45
O
rotating angle at the level of 45 O / gradient 45
Circular saw: external diameter x fixing diameter x maximum thickness
Minimum dimensions of the material to be processed: height x length x thickness
Mass
Level of noise
- acoustic pressure L ± K
pA
- power L ± K
wA
Level of vibration
Class of insulation
Grade of protection
GENERAL SAFETY RECOMMENDATIONS
ATTENTION! In case of using electric tools, it is required to follow basic safety regulations, which will reduce the risk of fire, electric
shock and injuries.
Before you proceed to operate the tool, get acquainted with the manual and keep it.
Keep the working area clean. Dirty places and tables increase the risk of injuries.
Pay attentions to the surroundings of the working area. Do not expose the tool to precipitation. Do not use the tool in humid or wet
environment. Provide adequate illumination of the working area. Do not use the tool close to inflammable liquids or gases.
Protection from electric shock. Avoid any contact of the body with grounded surfaces (e.g. pipes, heaters, burners, refrigerators).
Keep bystanders away. Do not allow bystanders, and particularly children, who do not participate in the tasks being realised, to
touch the tool or the extension cord. Bystanders must be kept away from the working area.
Storage of the tool. The tool must be stored in a dry and closed place, out of reach of children.
Do not overload the tool. The work will be more efficient and safe, if the tool is operated in accordance with its purpose.
Use and adequate tool. Do not overload a small tool in tasks in which heavy duty tools should be used. Do not use tools for pur-
poses they have not been designed for, for example do not use disc sawing machines to cut trees, logs or branches.
Wear adequate clothing. Do not wear loose clothes or jewellery, since they might get caught by the moving elements of the tool.
O R I G I N A L
12
O
O
O
O
I N S T R U C T I O N S
GB
Unit of measurements
[V]
[Hz]
[W]
[min -1 ]
[mm]
[mm]
[mm]
[mm]
[mm]
[mm]
[kg]
[dB(A)]
[dB(A)]
[m/s ]
2
Value
YT-82170
~230
50
1800
4800
68 x 150
65 x 85
35 x 150
35 x 80
255 x 30 x 3,0
20 x 200 x 20
12,5
95,2 ± 3
108,2 ± 3
2,936 ± 1,5
II
IP20