Technical Data - YATO YT-84920 Manual De Instrucciones

SPECIFICATION OF THE PRODUCT
Chain saw is designed only for wood cutting. Due to the electric drive of the saw, it is possible to cut under the roof or near
buildings. The chain saw can also be used for trees cutting, however, because of the threat, it is required, that trees cutting is
performed by an experienced user. Correct, reliable, and safe operation of the device is dependent on its proper use, therefore:
Prior to working with the tool, you should read all the instruction and keep it around.
For any damages or injuries caused by the tool misuse, resulting from failure to comply with its designation, no compliance with
with safety regulations and recommendations included in this manual, the supplier does not accept any liability. The tool misuse
causes also the loss of user's rights to the guarantee and warranty.
PRODUCT EQUIPMENT
The product is supplied in a complete state, but before its first use requires to be assembled.
Along with the chain saw there are supplied:
- chain guide
- cutting chain
- guide shield

TECHNICAL DATA

Parameter
Catalog number
Rated voltage
Rated frequency
Rated power
Speed of the chain travel
The length of guide bar
Chain scale
Chain spread
Chain type
Type of the chain guide
Number of teeth of the chain drive wheel and scale
Electric protection class
Oil tank capacity
Weight (without the battery, guide and chain)
Noilse level
- L (pressure)
pA
- L (power)
wA
Vibrations
Degree of protection
GENERAL SAFETY CONDITIONS
NOTE! Get acquainted with all the instructions below. Failure to observe them may lead to an electric shock, fire or injuries. The
notion of electric tool used in the instructions applies to all the tools which are powered with electric current, both wire tools and
wireless ones.
OBSERVE THE FOLLOWING INSTRUCTIONS
Place of work
The place of work must be properly illuminated and clean. Disorder and poor illumination may be a cause of accidents.
Do not work with electric tools in explosive environments, or those which contain inflammable liquids, gases or vapours.
Electric tools generate sparks, which may cause a fire in case of contact with inflammable gases or vapours.
Do not allow children and outsiders to the place of work. A lack of concentration may result in a loss of control over the tool.
Electric safety
The plug of the power supply cable must fit the mains socket. Do not modify the plug. Do not use any adapters whatso-
ever in order to adapt the plug to the socket. Unmodified plug which fits the socket reduces the risk of an electric shock.
O R I G I N A L
GB
Unit
[V]
[Hz]
[W]
[m/s]
[mm /'']
[mm]
[mm]
160SDEA041 / 295056 / 534038 / 509877 / 548851, Oregon
[ml]
[kg]
[dB (A)]
[dB (A)]
[m/s ]
2
I N S T R U C T I O N S
Value
YT-84920
230~
50
2200
11
400 / 16
9.525
19
91PJ057X / 91P057X, Oregon
6 teeth x 9.525 mm
II
230
5,1
87.5 ± 0.88
104.88 ± 0.88
4.552 ± 1.5
IPX0
13