No change in measurements with drain
shown. (K-7167-AF or K-7167M-AF)
Recommended faucet area.
Product Information
Pump on left
Pump on right
Required accessories:
Grip rails (pair)
Fixture:*
basin area
Bathing well
40" (101.6 cm) x
27" (68.6 cm)
water depth
To overflow
16" (40.6 cm)
* Approximate measurements for comparison only.
Pump
Heater
2 hp
1.5 kW
Cut-out template
Required Electrical Service
Dedicated circuit required, protected with a Class A
Ground-Fault Circuit-Interrupter (GFCI) or Earth-Leakage
Circuit-Breaker (ELCB):
Pump/control
220-240 V, 20 A, 50/60 Hz
1023229-1-B
2-3/4" (7 cm) Max.
3" (7.6 cm) x 24" (61 cm)
Flat Faucet Deck
Pump/Control Access
34" (86.4 cm) W x
15" (38.1 cm) H Min.
42" (106.7 cm)
2" (5.1 cm)
1-1/2" OD
K-1457-LV
shown
K-1457-RV
not shown
K-9653
top area
61" (154.9 cm) x
32" (81.3 cm)
capacity
90 gal. (341 L)
Voltage
Frequency
Amperage
240 V
50/60 Hz
15 A
113311-7
5-1/2" (14 cm)
Max.
33-1/2" (85.1 cm)
3" (7.6 cm)
Installation Notes
NOTE: Pump protrusion beyond rim.
Install this product according to the installation guide.
Floor support under whirlpool must provide for a minimum of
1850 lbs. (839.1 kg).
Hot water supply should be 70% of capacity or greater.
Installations will vary.
If installing a rim mount faucet, make sure there is no interference
weight
with drain overflow and circulating system before drilling any
160 lbs.
holes. Consult local and national codes for minimum air gap
(73 kg)
requirements if installing a spout on the faucet deck.
Fixture conforms to ANSI Standard Z124.1. All dimensions are
nominal.
2
Note: Pump/piping protrudes
beyond rim.
6-1/2"
(16.5 cm)
67" (170.2 cm)
3-1/2"
(8.9 cm)
2-7/8" (7.3 cm)
13-1/2"
(34.3 cm)
22"
(55.9 cm)
Kohler Co.