Dreame VTE1 Manual Del Usuario página 9

Care & Maintenance
3. Remove the pre-filter first, then lift the handle of the cyclone assembly and turn to
counterclockwise until it stops, then pull to lift out the cyclone assembly.
1
4. Rinse the cyclone assembly, pre-filter and dust compartment until they are clean. After
washing, air dry at least 24 hours .
Dust Compartment Cyclone Assembly
Note:
• It is recommended to clean the dust compartment once every month.
• It is recommended to clean the pre-filter at least once every 3 months and the cyclone
system at least once every 6 months.
14
2
3
12
11 1
10 2
24 hrs
9 3
8 4
7 5
6
Pre-filter
Care & Maintenance
Installing the Dust Compartment, Pre-filter, and Cyclone Assembly
1. Insert the cyclone assembly vertically into the dust compartment, and make sure
that the handle of the cyclone assembly line up with the slot on the left side of the dust
compartment. Turn the handle clockwise until it locks, then flip the handle down.
2. Place the pre-filter with its front side facing up into the cyclone assembly.
3
1
3. Slightly tilt the dust compartment so its slot aligns with the clip on the vacuum cleaner.
Then gently push the dust compartment until it clicks into place.
2
3
15