TRAPP TR 600 Manual De Instrucciones página 69

Assembling Output Device
Fit output device (1) on shredder cover (2),
position and tighten with butterfly nut (3)
and hex-nut (4).
1
2
Attaching to Tractor
Carefully read Operator's Manual, tractor
and cardan instructions manuals. Shredder
TR 600T has been manufactured to be
coupled to a tractor equipped with a
hydraulic lift of three universal connecting
points, as shown below.
Before connecting the equipment to the
✔
tractor, place both on flat ground and
make sure nobody stands between
them.
Installation
Slowly approach shredder to the lift
✔
arms. First, connect the lower arms and
then the upper arm. The shredder is
equipped with category I securing pins.
Make sure pins are secured to the
✔
corresponding safety lock.
Block lift arms with respective chain or
✔
anti-vibration stretchers.
After that, make sure all machine
screws and nuts are properly
tightened (see table "Torque
3
Specifications").
4
Pay attention to tractor front wheels.
When shredder is lifted, and the
wheels seem to light, place ballast on
the front part of the tractor.
67
ENGLISH