Checking Battery; Belt Adjustment - TRAPP TR 600 Manual De Instrucciones

Checking Battery

Remove closing protection (1) and loosen
battery securing bar (2). Remove battery
from base (3), check for charge in the
viewer.
Note:
When replacing battery on the
✔
base, make sure to properly
connect cables.
Red cable: (+) Positive
Black cable: (–) Negative
Frequently check belt pressure. The belt
✔
is located under the side guard.
Unscrew guard to check belt pressure. If
necessary, adjust it or replace it. When
belt pressure is not enough, its life is
compromised.
Belt pressure for shredders TR 600E and
✔
TR 600G is adjusted through the
stretching roll – under belt side guard.
To start the motor, lever (1) must be in
✔
position (A) when the motor reaches
maximum revolution; slowly unlock
lever to position (B).
Do not operate shredder without belt
✔
protection guard.
3
2
1

Belt Adjustment

68
ENGLISH
Attention!
If equipment is not used for
✔
more than 30 (thirty) days, you
may run out of battery.
To prevent corrosion and loss of
✔
power during long storage,
disconnect battery cables.
Disconnected cables must not
✔
get in touch with battery
terminals.
1
A
B
1
A
B