Maintenance Schedule; Maintenance And Servicing - TRAPP TR 600 Manual De Instrucciones

2 - Inspect whole equipment, and replace
damaged/worn parts.
3 - Firmly tighten all screws and nuts (see
table "Torque Specifications").
4 - Lubricate and cover the whole
equipment with canvas. Keep it in a
dry place, protected from weather
conditions.
Maintenance is essential to extend the life
of any farming equipment, to improve
performance and provide greater safety.
The operation times indicated in this
manual are to be used as a reference for
normal usage conditions. They can vary
according to the type of service,
environment, seasonal factors etc.

Maintenance Schedule

Every 10 working hours
At the end of every working day, clean
✔
the machine so that its parts are always
in good working conditions.
Lubricate cardan crosshead.
✔
Check for hydraulic oil leak and for
✔
damaged parts.
Make sure blades are in good
✔
condition, sharp and properly secured.
Follow these instructions to always have
your shredder in good working
conditions.
Maintenance
Every 25 working hours
Lubricate rotor bearings through
✔
grease fittings.
Lubricate transmission shaft bearings
✔
through grease fittings.
Every 50 working hours
Check whether belts are properly
✔
stretched.
Check whether all screws and nuts
✔
are properly tightened.

Maintenance and Servicing

Before servicing the machine, stop the
motor, disconnect from TDP, use
parking brakes and place equipment
horizontally on the ground.
73
ENGLISH
Attention!
Do not use a water jet to clean
the equipment. Water in the
bearings can damage them.