Using Your Shower / Bath Filler - Kohler K-527 Guia Del Usuario

Using Your Shower / Bath Filler

Bath Filler Systems Only
NOTICE: Risk of property damage. To prevent overflow, do not leave the bath filler running unattended.
IMPORTANT! For systems with both a bath filler and shower: When setting the default temperature, set
the default for comfortable showering; refer to the "Temperature – Set the Default" section. Adjust your
desired bathing temperature manually as needed.
Turn ON/OFF Your Shower/Bath Filler
Press the [Power Icon] to turn ON your system. Your temperature will be set according to the
default. If your system was used within the last 2 minutes, the temperature will be the same as the
last use.
NOTE: The displayed temperature is the set temperature. The temperature displayed will blink until the
actual temperature reaches the set temperature.
Press the [Power Icon] and hold for 2 seconds to turn OFF your system.
Decrease the Temperature
Decrease the temperature by pressing the [Down Icon]. One icon press = 1°F (0.5ºC).
Press and hold the [Down Icon] to decrease the temperature; the temperature setting will change by
1°F (0.5ºC) every 0.5 seconds.
Increase the Temperature
Increase the temperature by pressing the [Up Icon]. One icon press = 1°F (0.5ºC) up to 106°F (41°C).
NOTE: For temperatures of 106°F (41°C) and above, the system will only allow icon presses that are 2
seconds or more apart.
Press and hold the [Up Icon] to increase the temperature, the temperature setting will change by 1°F
(0.5ºC) every 0.5 seconds up to 106°F (41°C); and every 1 second for temperatures above 106°F
(41°C).
1144502-5-D 4 Kohler Co.