Operating And Programming; Assemble And Charge - ECOVACS DEEBOT D77 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

3. Operating and Programming

3.1 Assemble and Charge

Charging Dock Placement
5 feet
Charge the Robot
Turn the switch on the bottom of the robot to the ON position.
Place the robot on the Charging Dock making sure the Charging Dock Electrode and the Charging Pin on the
robot make a connection.
Three Ways to Charge
Automatic Charging
The robot can perceive a low
battery when it is working,
and will automatically switch
to Back to Charger mode when
necessary.
Charging indicator light blinks when the robot is charging
Charging normally takes about 3-5 hours
After charging finishes, the charging indicator light turns off
Note
The robot should be charged at least 12 hours during the first 3 uses.
After the robot's battery is fully charged, DEEBOT's battery management system will reduce to a trickle charge
to save electricity.
When the robot is on the Charging Dock, please make sure charging indicator light is blinking.
Remove batteries if the robot will not be used for a long time.
When the batteries are fully discharged or not used for a long time, their capacity may decrease, so it's
suggested to reactivate them.
Method of reactivating batteries: place the robot on the Charging Dock by hand, remove after charging for
3 minutes; repeat 3 times, then charge normally for 3-5 hours.
Place the Charging Dock on a level floor surface with the base perpendicular to the
ground. Keep the immediate area in front of the charger (1.5 m or approx. 5 feet)
clear of objects and reflective surfaces that would interfere with the infrared receiver.
Command Charging
You can command the robot
to switch to Back to Charger
mode at any time with the
Remote Control or the button
on the robot's control panel.
EN
Manual Charging
Turn ON the power switch on the
bottom of the robot and place it
on the Charging Dock by hand.
Ensure that the Charging Dock
Electrode and the Charging Pin
on the robot make a connection.

Publicidad

Tabla de contenido
loading

Tabla de contenido