Teka DM-60 Manual De Instrucciones página 16

Manual DM TEKA.qxd
Cleaning and maintenance
During cleaning and maintenance work,
make sure the safety instructions set out
on page 14 are complied with.
Cleaning the hood body
• If your kitchen hood is made from stainless
steel, use proprietary cleaners mentioned
in the product instructions.
• If your kitchen hood is painted, use
lukewarm water and a neutral soap.
• Never use metallic scourers, nor abrasive
or corrosive products.
• Dry the kitchen hood using a cloth that
does not produce fibres.
Cleaning the metal filters
To remove the filters from their fittings, press
lightly on the locks and then pull them off.
The metal filters can be cleaned by soaking
them in hot water with neutral detergent until
the fat dissolves and then rinsing them under
_________________________________________________________
Proceed with the following checks before calling Technical Services:
Problem
The extractor fan does not work.
The kitchen hood does not extract
sufficiently or vibrates.
The lamps do not light up.
16
14/04/2003 11:42 PÆgina 16
Problem solving
Possible cause
The mains cable is not connected to the
network.
There is no current in the network.
Filters are saturated with fat.
Obstruction in the air exit conduct.
The lamps are blown.
The lamps are slack.
the tap or using special anti-grease products.
They can also be washed in a dishwasher. In
this case, it is advisable to stack them
vertically to avoid food residues to stick to
them.
Cleaning in a dishwasher with aggressive
detergents or polish may damage the metallic
surface (blackening it), although this will not
affect its fat retention capacity.
Once clean, leave them to dry off and then fit
them onto the kitchen hood.
Changing light bulbs
Proceed as follows:
• Remove the metal filters.
• Change the broken/burnt out lamp.
Maximum lamp power is 40 W (E-14).
• Fit the metal filters.
Solution
Connect mains cable to the network.
Provide current to the network.
Change or clean the active charcoal and/or metal
filters, as the case may be.
Remove the obstruction.
Change the lamps.
Tighten the lamps.