Össur Vari-Flex Junior Instrucciones Para El Uso página 7

• Roughen the upper and lower surface of the wedge with
abrasive paper.
• Place the wedge in the angle of heel and foot module
• Secure in position with tape wrapped around the foot module
(Figure D).
II Permanent Wedge Placement
• Apply adhesive on the lower side of the wedge only (1).
• Locate in the foot/heel junction and position before adhesive sets.
• For split toe feet install the heel wedge then remove a thin slice in the
middle by cutting with a sharp knife through the split in the carbon
foot module (Figure E).
Instant adhesive is necessary to bond the urethane heel wedge. The
adhesive cures in 15-20 seconds.
HEEL ASSEmBLy
If it is necessary to replace the heel component use Loctite 410 and
torque to following specifications:
Category
1-4
HEEL DIVIDER
The heel divider should be placed in the last third of the splitted heel
part. To secure its position a drop of instant adhesive can be used on
one side.
BOLT CAP REmOVAL
If it is necessary to remove the bolt cap locate the foot module/bolt cap
junction and use a sharp knife to separate.
FLEx-FOOT SOCK WITH EVO
The toe end of the sock is divided by a thread and fits within the toe split.
Upon fitting the sock, hold the top of the toe thread and slide the sock
into the toe split. The thread of the sock should rest on top of foot
module and not underneath the toe split. The sock should be loose from
the heel area and secured proximally with the cable tie provided.
SHOE HORN (Figure F&G)
When removing and installing the cover use shoehorn to avoid damage
to foot or cover.
Bolt Size
1/4"
Heel Bolt Tourque
14Nm (10ft-lbs)
7