Publicidad
STEP 1
Attach (1) back bracket and (1) side
mount bracket to each slide using
(2) #8-32 flat head screws and (2)
lock nuts each (See Figure A).
STEP 2
Decide the height of the drawer
box and mark the inside left wall
of the cabinet near the front, fold
template on the dotted line, then
align the top of the template with
the mark and tape in place (See
Figure B).
A. Face frame cabinet – cut
or fold template to the dotted
line and place to back of the
face frame.
B. Inset cabinet – set template
back the thickness of the door.
STEP 3
Mark the cabinet wall at the (3)
screw locations (denoted by
center marks on the template) and
remove template.
STEP 4
Place the side mount bracket on
the inside wall, aligning the holes
to the marks and attach using (3)
#8 x 5/8"
truss head screws provided (See
Figure C).
Repeat steps 2-4 for the right wall.
#2
#2
#2
2
FIG. A
FIG. B
FIG. C
Customer Service: 800-626-1126 | rev-a-shelf.com
I-486VSM-1217
Publicidad
