Publicidad
STEP 5
Measure the inside cabinet width
(ICW) and subtract 25 (See Figure
D). Take that number and divide
by 2, this is dimension "A".
"A" = (ICW – 25) ÷ 2 = ____
STEP 6
Place left slide with side mount
bracket from Step 1 on top of left
side mount bracket from Step 4.
Insert (2) #8-32 flat head screws
and (2) lock nuts into the slots
then measure from cabinet wall to
the side mount bracket's vertical
wall until it is dimension "A" and
tighten screws/lock nuts (See
Figure E).
NOTE: The top side mount
bracket can be flipped for a
lower shelf height (See Figure F).
STEP 7
Adjust the back bracket to lay
flush against the cabinet rear wall
and attach with (2) #8 x 5/8" truss
head screws (See Figure G).
Repeat steps 6-7 for right side.
FIG. D
FIG. E
Cabinet Wall
FIG. G
INSTALLATION INSTRUCTIONS: VANITY SIDE MOUNT U-SHAPED PULLOUT
Overhead Cabinet View
ICW
Door
Slide
Side Mount Bracket
from Step 1.
Side Mount Bracket
from Step 4.
Cabinet Wall
FIG. F
Side Mount Bracket
from Step 1.
Slide
Side Mount Bracket
from Step 4.
I-486VSM-1217
Publicidad
