Publicidad
Idiomas disponibles
Idiomas disponibles
Chevy and GM 2011 – Current 2500 HD & 3500 HD Silverado and Sierra
Read pages 1-3 of these instructions before starting installation. Failure to do so could result in significant vehicle damage!
IMPORTANT NOTES FOR THIS INSTALLATION:
1.
Find parallel rows of bed sill spot welds in bed of truck. No drilling should be done in the approximately 4" between
parallel rows of spot welds where the bed sill sets.
Front of
Vehicle
Fifth wheel hitches over 18k
must have a center bolt in the
center hole in both rails.
Note: Place center bolt in the
hole that does not interfere
with the bed sill. If needed, flip
the rail around.
Center bolts and hardware
are supplied with Fifth wheel
or gooseneck hitches that are
rated over 18k.
Front of
Vehicle
Short Bed Sills
1/4
1.5-3
*
1/4
2
Check for obstructions before drilling. Failure to do so could result in damaged fuel or brake lines, structural members, etc.
Cequent Performance Products, Inc. does its best to communicate tow vehicle manufacturer changes; however, it is ultimately
30095N 6/13/14 REV. K
Long Bed Sills
Straight frame
bracket
Note: Pull wire provided, will be needed to install
hardware in brackets through frame.
the responsibility of the installer to prevent damage due to installation.
©2014 Cequent Performance Products, Inc.
CAUTION!
King pin
Axle center
CAUTION!
Rear Edge of
Truck Bed
Long Bed = 29 11/16"
Short Bed =25 3/16"
Measure from rear edge of
truck bed to rear edge of
base rail
* Optional weld
pattern
Drivers side of 3/4 ton HD shown
1/4
1/4
Angled bracket
On inside of frame
PRINTED IN CHINA
2
*
2
4
Publicidad
