Publicidad
Idiomas disponibles
Idiomas disponibles
Chevrolet & GMC 73 to 87 & 73 to 92 4-door
Read pages 1-3 of these instructions before starting installation. Failure to do so could result in significant vehicle damage!
IMPORTANT NOTES FOR THIS INSTALLATION:
1.
Find parallel rows of bed sill spot welds in bed of truck. No drilling should be done in the approximately 4" between
parallel rows of spot welds where the bed sill sets.
Front of
Vehicle
Fifth wheel hitches over
18k must have a center
bolt in the center hole in
both rails.
Note: Place center bolt in
the hole that does not
interfere with the bed sill. If
needed, flip the rail around.
Center bolts and hardware
are supplied with Fifth
wheel or gooseneck
hitches that are rated over
18k.
King Pin Center approx.
Long bed 3 1/2" & short
bed over the Axle Center
Straight Bracket
Front of
Vehicle
1/4
*
1/4
Check for obstructions before drilling. Failure to do so could result in damaged fuel or brake lines, structural members, etc.
Cequent Performance Products, Inc. does its best to communicate tow vehicle manufacturer changes; however, it is ultimately
30095N 6/13/14 REV. K
1.5-3
2
Note: Pull wire provided, will be needed to install
hardware in brackets through frame.
the responsibility of the installer to prevent damage due to installation.
©2014 Cequent Performance Products, Inc.
(34" Straight, with Inside Shock Absorbers)
CAUTION!
Center
Hole
Center
Hole
Axle Center
Bed Sill
Angled Bracket
CAUTION!
Rear Edge of
Truck Bed
Long Bed =33 3/16"
Short Bed =23 3/16"
Measure from rear edge of
truck bed to rear edge of
base rail
Left, right angle and frame
brackets maybe place where
ever brackets fits best.
Drivers side of 1/2 ton Chevy Long Box Shown
1/4
2
*
1/4
2
* Optional weld
pattern
PRINTED IN CHINA
7
Publicidad
