LG Centric PCS200R Pro Instalación Y Configuración De Referencia Rápida página 16

System Setup (Cont.)
(Continued from previous page)
9. This step describes how to set a static IP address for the Control Port and/or
Feature Port.
Caution: Setting a static IP address for the Control Port (for remote
management purposes) is optional. However, if you will be using IP output
from the PCS200R, you MUST configure the Feature Port as described in
step (c) below.
a) At the Command > prompt, type setip and press Enter. The system will display
the current network configuration, followed by the Network Configuration Menu.
Use the Network Configuration Menu commands indicated below and follow the
system prompts to configure the port(s). Refer to the extended Installation &
Setup Guide for further information on the commands.
b) Use the "eth0" and "dns" commands to configure the Control Port, as necessary.
c) Use the "eth1" command to configure the Feature Port, if required, for PCS200R IP
output.
Note that the Feature Port MUST be configured with a static IP address that is on
the same network as the TV(s). Also, make sure the Feature Port speed (default:
1000 Mbps) is appropriate for your system. If necessary, at the prompt for the port
speed, change the value to 100 Mbps.
d) When you are finished with network configuration, type exit at the Network
Configuration Menu > prompt. The system will display an overview of the new
network configuration and then prompt for confirmation to save the changes:
Do you want to save the new configuration? [y/n]:
Type y or n and press Enter, as appropriate.
Note: Review the New Network Configuration overview carefully before you confirm
the configuration settings. Ensure each of the addresses was entered correctly.
Note: If you changed the configuration of the port(s), you will be prompted to reset the
system. You may wait to reset the system until you are directed to do so in step 11.
16
(Continued on next page)