LG Centric PCS200R Pro Instalación Y Configuración De Referencia Rápida página 5

IMPORTANT SAFETY INSTRUCTIONS
Do NOT run your fingers over the top and
bottom covers of the unit.
26. Do not block any of the ventilation open-
ings. Install in accordance with the manu-
facturer's instructions.
- The product can be deformed or fire can
break out due to overheating inside the
product.
27. Do not place the product in a built-in instal-
lation such as bookcase or rack.
- Ventilation required.
28. DISCONNECTING DEVICE FROM MAINS
- Mains plug is the disconnecting device.
The plug must remain readily operable.
29. Do not place anything containing liquid on
top of the product such as flowerpot, cup,
cosmetics or candle.
- This may cause a fire hazard.
PCS200R Rack Installation (also see pages 9 to
10)
To install the PCS200R in a rack:
•
Carefully slide the PCS200R into a standard 19-
inch equipment rack.
•
When mounting in the rack, make sure to use
the appropriate hardware. ALL FOUR MOUNT-
ING SCREWS MUST BE USED.
•
This equipment is not designed to support other
devices. Do NOT stack other equipment on the
top of the PCS200R.
•
Rear cabling must be dressed and supported so
that the weight of the cabling is not a strain on
the PCS200R connectors.
•
MOUNTING OF THE EQUIPMENT IN THE
RACK SHOULD BE SUCH THAT A HAZARD-
OUS CONDITION IS NOT ACHIEVED DUE TO
UNEVEN MECHANICAL LOADING.
Rack-mount Considerations
A. Elevated Operating Ambient
If installed in a closed or multi-unit rack assem-
bly, the operating ambient temperature of the
rack environment may be greater than room
ambient. Therefore, consideration should be
given to installing the equipment in an environ-
ment compatible with the maximum ambient
temperature (Tma) specified by the manufac-
turer. See specifications information in this
document.
B. Reduced Air Flow
Installation of the equipment in a rack should
be such that the amount of air flow required
for safe operation of the equipment is not
compromised. To ventilate the system normally
and avoid overheating, leave at least 1 inch
(2.5 cm) on each side (including top and bot-
tom) of the PCS200R. Do NOT stack other
equipment on the top of the PCS200R. Also,
ensure that the unit's AC power adapter is
never stacked or bundled with other AC power
adapters. Each adapter should have adequate
ventilation and should be isolated from other
heat sources.
C. Circuit Overloading
Consideration should be given to the
connection of the equipment to the supply
circuit and the effect that overloading of the
circuits might have on overcurrent protection
and supply wiring.
D. Reliable Earthing
Maintain reliable earthing of rack-mounted
equipment. Particular attention should be
given to supply connections other than direct
connections to the branch circuit (e.g. use of
power strips).
E. Mains Outlet Earthing
The apparatus with Class I construction must
be connected to a mains socket outlet with a
protective earthing connection.
5