LG Centric PCS200R Pro Instalación Y Configuración De Referencia Rápida página 17

(Continued from previous page)
10. (Optional) Set the date and time on the PCS200R.
By default, the PCS200R is synchronized with an NTP server and configured for the
US Eastern time zone. If the PCS200R is connected to the Internet, the NTP client will
periodically update the time setting on the PCS200R. You can set the time zone as
required. If the PCS200R is not connected to the Internet, you also have the option to
disable NTP synchronization and specify date and time data manually.
Use the PCS200R "tz" and/or "time" commands (available from the Command >
prompt), as necessary, to set the date and time on the PCS200R.
•
Use the "tz" command and follow the system prompts to change the time zone.
•
Use the "time" command and follow the system prompts to change the NTP
configuration or manually configure the date and time parameters on the PCS200R.
Refer to the extended Installation & Setup Guide for further information on these
commands.
Note: If you changed the time zone and/or the NTP configuration, you will be
prompted to reset the system. Continue with step 11, where you will be directed to
initiate a reset.
11. If you made any configuration changes in steps 9 and 10 that require a system reset,
at the Command > prompt, type reset and press Enter.
The reset process may take up to two minutes, after which the PCS200R resumes
normal operation.
12. Make the appropriate connection to the RF distribution system or IP distribution
network depending on the PCS200R output option to be used.
•
ASI output: Connect the RF output on the upconverter to the RF distribution center
combiner, and balance the RF signal so that the Pro:Centric signal level at the
TV(s) is between 0 to +7 dBmV.
•
RF output: Connect RF OUT on the PCS200R to the RF distribution center
combiner, and balance the RF signal so that the Pro:Centric signal level at the
TV(s) is between 0 to +7 dBmV.
•
IP output: Connect a CAT5E or better Ethernet cable between the Feature Port on
the PCS200R rear panel and the institution's IP distribution network.
System Setup (Cont.)
(Continued on next page)
17