LG Centric PCS200R Pro Instalación Y Configuración De Referencia Rápida página 8

Rear and Front Panel Overviews
PCS200R Rear View
Disconnect Device
The AC mains plug is used as the disconnect device.
The disconnect device must remain readily operable.
RF OUT (0 dBmV) Connector
Reserved for service technician use only. When not
in use, this connector must remain terminated with
attached terminator accessory.
PCS200R Front View
Ventilation
Air flow must not be obstructed. To ventilate the system normally
and avoid overheating, leave at least 1 inch (2.5 cm) on each side
(including top and bottom) of the PCS200R. Do NOT stack other
equipment on the top of the PCS200R.
Screws with Lock Washers
Only qualified service personnel should handle and install the
PCS200R. A series of screws with lock washers are used to secure
the top and bottom covers of the PCS200R. Use caution when
handling the unit as the lock washers may have rough edges. Do
NOT run your fingers over the top and bottom covers of the unit.
8
SSD (OPTI ONAL
)
MAXI MUM CURR
ENT +5V DC @ 2.0A
MODEL: PCS200R
RF-OUT
DATE: xx/xx/xx
I IIIII IIIIIIII IIIIIIIIIIIIIIIII
III IIIIIIIIIIIIIIIII IIIII
0 dBmV *201-1252 008*
FIRMWA RE VER:
Rx.x
MAC ADDRES S:
<Eth0>
xx:xx:xx: xx:xx:xx
<Eth1>
xx:xx:xx: xx:xx:xx
SSD Slot
RF OUT
RF OUT
(for future SATA
(0 dBmV)
solid state drive
functionality) ASI OUT
& CONTROL
(Ethernet) Ports
POWER LED
RF-OU T
ASI-O UT Featu re Port
Contr ol Port
POW ER
Servi ce Port
12V
Service Port
USB Port
(reserved for
FEATURE
future functionality)
AC Power
Cord & Adapter
PWR