Before use
Included accessories
Check to be sure the box includes all the supplied accessories shown
below . Please contact the store where you purchased this product if
any of these accessories are missing or have been damaged during
transportation .
Power cord × 1
Remote control (RC-1334) × 1
Batteries for remote control (AA) × 2
Felt pads × 3
Owner's manual (this document) × 1
Warranty card × 1
Note about pinpoint feet
High-precision metal pinpoint feet are attached to the bottom plate
of this unit .
The pinpoint feet and their stands are loose, but when the unit is
placed in position, it is supported by these pinpoint feet, which effec-
tively disperse vibrations .
Chassis
placement
Foot-stand (metal)
Pinpoint foot (metal)
o Apply the included felt pads to the bottoms of the foot-stands to
avoid scratching the surface where the unit is placed .
After
Precautions for use
o This unit is very heavy, so take care to avoid injury during
installation .
o Do not place anything on top of the unit .
o Do not install this unit in a location that could become hot . This
includes places that are exposed to direct sunlight or near a radia-
tor, heater, stove or other heating equipment . Moreover, do not
place it on top of an amplifier or other equipment that gener-
ates heat . Doing so could cause discoloration, deformation or
malfunction .
o In order to enable good heat dissipation, leave at least 20 cm (8")
between this unit and walls and other equipment when installing
it . If you put it in a rack, for example, leave at least 5 cm (2") open
above and 10 cm (4") open behind it .
Failure to provide these gaps could cause heat to build up inside
and result in fire .
o Place the unit in a stable location .
o Do not move the unit during use .
o Be careful to avoid injury when moving the unit due to its weight .
Have someone help you move it if necessary .
o The voltage supplied to the unit should match the voltage as
printed on its back . If you are in any doubt regarding this matter,
consult an electrician .
o Do not open the body of the unit as this might result in damage
to the circuitry or cause electric shock . If a foreign object should
get into the unit, contact your dealer .
o When removing the power plug from the wall outlet, always pull
directly on the plug; never yank on the cord .
7