Attaching/disconnecting the battery
pack to/from the appliance
Inserting the battery pack
♦
Allow the battery pack
in the appliance.
Removing the battery pack
♦
Press the release button
battery pack
.
Checking the battery charge level
♦
Press the battery charge level button
the status of the battery (see also main diagram).
The status will be shown on the battery display
LED
as follows:
RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery
Fitting/changing the saw blade
WARNING!
►
Remove the battery before carrying out
any work on the power tool (e.g. mainte-
nance, changing tools, etc.) as well as during
the transport and storage of the power tool.
Unintentional activation of the ON/OFF
switch can result in injury.
♦
Turn the quick-release chuck
stop and hold it in this position.
♦
Push the required saw blade
quick-release chuck
│
GB │ IE
■
8
to click into place
and remove the
to check
as far as the
into the
as far as the stop.
CAUTION!
►
The teeth of the saw blade
downwards!
♦
Let go of the quick-release chuck
returns to its initial position. The saw blade
is now locked.
Adjusting the footplate
RISK OF INJURY!
►
Always switch the appliance off and remove
the battery before carrying out any work on
the appliance.
♦
Adjust the footplate
depth.
♦
To do so, undo the locking lever
the footplate
to the corresponding position.
♦
Lock this position by closing the locking lever
Adjusting the pendulum stroke
♦
You can use the pendulum stroke switch
to adjust the pendular movement of the saw
blade
. You can achieve fine, clean-cut edges
without pendulum movement (setting "0").
Deactivate pendulum movement when working
on thin workpieces. You can achieve an increas-
ingly fast work rate if the pendulum stroke is
activated (setting "I").
must point
so that it
according to the cutting
and move
PSSA 20-Li A1
.