Safety Switch - Everbilt CSP010 Guía De Uso Y De Mantenimiento

Operation (continued)

SAFETY SWITCH

The safety switch is designed to activate an alarm (sold separately) or to cut off power in the event of high water in the condensate
reservoir.
To control a thermostatic circuit the COM and NO connections from the safety switch are to be wired in series with the low voltage
thermostat circuit to shut down the heating/AC circuit. The COM and NC switch contacts may be used to actuate a low voltage alarm circuit
(connected in series) if the heating/cooling system cannot be disrupted.
TESTING
1. Unplug the condensate pump so that it cannot pump out water. Fill water into the pump reservoir until it is almost full. The safety switch
should activate before the float contacts the cover.
2. Plug in the condensate pump. The float should activate the pump and pump the water out.
As the water level goes down in the reservoir, the safety switch should reset, allowing the appliance to start or shut off the alarm.
6