Communication - MGE UPS Systems Pulsar ESV 8+ Manual De Instrucciones

communication

The communication port 9 , at the rear of
Pulsar, delivers information in the form of an
RS232 series link supported by the
communication protocol exclusive to
MGE UPS SYSTEMS. The Solution-Pac
programs use the data made available by
this protocol.
RD TD
0V
1
5 4 3 2
9
9 8 7 6
I
1 - ground
2 - TD
3 - RD
V
5 - common
ESV Driver software (included in the CD-ROM:
EMB/ESVPLUS/CONFIG) lets you edit the
default parameter of Pulsar:
c battery test frequency
(default: every week);
c nominal output voltage
(default: 230 Volts);
c high/low voltage thresholds
(defaut: 264/184 Volts);
c Fader/Booster activation thresholds
(defaut : 248/204 Volts);
c on/off conditions:
v automatic restart,
v forced reboot,
v energy saving,
v cold start.
22
option 1
c status information card: after the card is
installed in the rear of the Pulsar,
communication port 15 transmits status
information on a SUB-D 9-pin female
connector using the following pinouts:
1 - ground,
4 - normal operation,
5 - common,
7 - low battery warning,
9 - operation on battery.
0V
5 4 3 2 1
15
9 8 7 6
n.c. n.o. n.o.
0V 0V
Relay breaking capacity:
Vmax = 25V DC, Imax = 10mA
n.o. : normally open,
n.c. : normally closed.
Pulsar ESV +: E-51032616XT/AA
option 2
c SNMP card: after the card is installed in
the rear of the Pulsar, communication port
15 transmits information supported by the
SNMP protocol on an RJ45 or BNC
connector.
option 3
c battery extension module Pulsar EB
22XLA (for Pulsar ESV 22+):
Switch off Pulsar ESV 22+ (push button 3 ),
disconnect the input connection cord 5 .
Connect battery connection cord 19
(included with Pulsar EB 22XLA) to Pulsar
EB 22 and connect to Pulsar EB 22XLA.
You can connect 7 Pulsar EB 22XLA in
parallel.
Contact your retailer for further details.
MGE UPS SYSTEMS