Sigma EF-530 DG SUPER EO-ETTL II Instrucciones página 24

Wireless Flash Exposure Compensation
1. Please set master flash unit to the Wireless Flash Mode.
2. Press the SEL button to make
3. Press the + or - button to set the flash exposure compensation amount.
4. Press the SEL button several times to make exposure compensation indicator appear.
It is not necessary to make any additional setting on the Slave units.
◆
◆ You can also set the flash exposure compensation individually for each slave unit.
one slave, you will need to apply steps 2-4 to each slave unit.)
Wireless FE Lock
1. First please set the
2. Focus on the subject and press the FEL button on the camera.
3. The procedure for setting wireless EF lock is the same as for normal FE lock.
◆ It is not necessary to make any change to the settings on the Slave units.
Wireless Flash Exposure Bracketing (FB)
1. First set the flash to the Wireless Flash Mode.
2. On the Master Unit,
3. Press the + or - button and set the flash exposure compensation amount.
4. Press the SEL button several times to make
5. The remainder of procedure for setting wireless FB is the same as for normal FB.
◆ It is not necessary to change any settings on the Slave units.
Changing the Wireless Mode
Please set the flash as follows.
1. Press the MODE button to select the ETTL /
2. Press and hold the SEL button more than 2 seconds to make the mode indicator blink.
3. Press the MODE button and select the ETTL, M, or MULTI mode.
4. Press the SEL button to make the mode of indicator stop blinking.
Wireless Manual Flash
You can manually set the slave unit's flash output, with the master unit. The flash output among the slave
units can be uniform or varied. To determine the proper flash exposure, use a hand-held flash meter.
Wireless Manual Flash With Uniform Flash Output
Please set the Master flash unit as described below.
1. Please follow the procedure of Changing the
2. Press the SEL button several times to make the flash output amount indicator blink.
3. Press the + button or – button to set the flash output amount.
4. Press the SEL button several times
◆If the master flash unit ON function is set, the master unit will also fire, at the same flash output.
Wireless Manual Flash With Varied Flash Output
You can set a different flash output for each slave unit(s)
three slave flash units).
Please set the master flash unit as
1. Please follow the procedure for Changing the
2. Press the SEL button several times to make the
3. Press the + or - button to select
4. Press the SEL button, making the flash output display and
5. Press the + or - button to set the flash output amount for
6. Press the SEL button make
7. Press the + or - button to set the flash output amount for
8. Press the SEL button make
9. Press the + or - button to set the flash output amount for
10. Press the SEL button to make the indicator stop blinking.
23
mark blink.
flashgun to Wireless Flash mode.
press the SEL button several times to make the
until the display stops
Set the slave units to normal Wireless Flash mode.
follows.
the flash output display and
the flash output display and
indicator stop blinking.
the
mark.
Wireless Mode and set to the M／
blinking.
(the following
Wireless Mode and
mark blink.
indicator. (blinking)
blink.
ID
blink.
ID
blink.
ID
mark blink.
explains the procedure for
set to the M／
1.
2.
3.
(If using more than
mark.
using
mark.