Tabla de contenido
Publicidad
ENGLISH
INSTALLING AND SETTING OF NEW MACHINE BATTERY
WARNING!
The electric components of the machine can be seriously damaged if the batteries are either
improperly installed or connected.
The batteries must be installed by qualified personnel only. Set the battery charger (optional) according to
the battery type (WET or GEL/AGM).
NOTE
The machine requires two 12V batteries not exceeding the total size
connecting according to Figure 4.
The machine can be operated in one of the following mode:
Without Batteries
1.
Buy appropriate batteries (See the Technical Data paragraph). For battery choice and installation, choose
qualified battery Retailers.
2.
When batteries are ready, set the machine and the battery charger (if equipped) according to the type of
batteries. (Refer to the installation and settings of batteries)
WET or GEL/AGM batteries are already installed and re ady to be used
1.
Connect the battery connector (9) to the machine then turn on the power switch (45).
2.
If the green LED (42) is on, batteries are full charged for use. If the yellow or red LED (44 or 43) turns on, the
batteries must be charged (see the procedure in Maintenance chapter).
BRUSH OR PAD-HOLDER INSTALLATION AND UNINSTALLATION
NOTE
Install either the brush (A, Figure 5) or pad-holder (B and C, Figure 5) according to the type of
floor to be cleaned.
CAUTION!
Before installation or uninstallation of brush or pad-holder, make sure all the switches of
machine are in off position and lifting up the squeegee from the floor.
1. Make sure that the power switch (45) is turned to off position "o".
2. Lift the tank (25) by prying the handlebar (2).
3. Rotate the brush (A, Figure 5) or the pad-holder (B/C, Figure 5) in clockwise (direction of arrow mark D,
Figure 5) to install it to the deck.
4. Rotate the brush or the pad-holder in counterclockwise (direction of arrow mark E, Figure 5) to uninstall it
from the deck.
Figure 4
Figure 5
7
QUICK START GUIDE
L330 x W170 x H260 MM and
Publicidad
Tabla de contenido
