Care And Cleaning - Rampage 86615 Instrucciones De Instalación

5
Locate the 1-1/4 x 8-1/2 bolt and place it through
the top tube of the carrier. The mouting plate
can be configured multiple ways to accomodate
most wheels. See Figure 4
Set the distance based on your wheel back-
space and use the 1-1/4" nuts to secure the plate
in position. See Figure5
Thread the provided 1/2" bolts through the
mounting plate and tighten.
NOTE: The tire should be pressed tightly up
against the tire carrier
6
Adjust bumper so that is level side to side and
tighten all hardware.
Check swing away movement and latch
operation.
Install spare tire - double check the tire gets
pulled tightly to the tire swing to reduce tire
vibration.

Care and Cleaning

• Rampage Bumpers are built to last; any detergent you use to wash your vehicle is sufficient to clean the
bumper. Do not use any harsh abrasive detergents. Periodically check and lubricate moving parts, tire swing
pivot has a zerk fitting to grease joint.
Congratulations!
You have purchased one of the many quality Rampage branded products offered by Lund International. We take the
utmost pride in our products and want you to enjoy years of satisfaction from your investment. We have made every
effort to ensure that your product is top quality in terms of fit, durability, finish and ease of installation.
The material that your product is made from can
be recycled. Please also consider recycling the
packaging that your product came in.
800-328-2409
• Visit us at Rampageproducts.com
© 2018 Lund Motion Products, Inc. All rights reserved.
Rampage Products™ is a trademark of Lund Motion Products, Inc.
Page 3 of 3
Figure 4
Plate can be reversed for stock or smaller offset wheels
Set this distance to the same as the backspace of your wheels
Figure 5
3/4" Nuts
3/4" Bolt
A
Tire Carrier
3/4" Welded Nut
Adjust Disk to desired spacing. Then tighten
"C" to "D". Rotate the disc to the desired
position and tighten "A" and "B" to keep disk
from rotating.
Disk
B C D
1/2" Bolt