Before First Use - Cooke & Lewis CL60CGRF Manual Del Usuario

Controlling the cooker hood remotely
IMPORTANT: This section is only applicable if you have purchased the optional
Cooke & Lewis Induction Hob model CLIND60RF (EAN 3663602553069).
01

Before First Use

This cooker hood model CL60CGRF and the induction hob model CLIND60RF must be paired by
radio frequency before remote control can occur. This only needs to be done once.
When connected the power output of the induction hob will control the extraction rate of the
cooker hood.
02 To Set Up Connectivity
1. Make sure that the hob and the hood are switched off.
2. Press the Timer icon
alternately fl ash red and white.
3. Turn on the hob and make sure the connectivity indicator is lit red.
connectivity key
4. Press the keys
confi rm connection.
5. The control panel of the hood will show A for fi ve seconds to indicate connectivity has been
made with the hob.
6. Press the keys
IMPORTANT: The connectivity operation above must be completed within two minutes of
turning on the power to the hood. If this is not successful, switch off both the hood and the
hob, wait for one minute and attempt the connectivity again.
03 Using the connectivity function
1. Ensure the connectivity indicator is lit on the hob control panel.
2. The extraction rate of the hood will vary based upon the total power output selected on the hob,
as shown in the table. Each hob cooking zone has a maximum rated output of 10 comprising
1-9 and Boost (10).
and Light icon together on the control panel. The LED display will
on the hob if it is not lit.
and together on the hob and the connection indicator will fl ash to
and together on the hob one more time to store the connectivity settings.
Note: Touch the
31