Assembly Instructions - Harbor Breeze 00593 Manual De Instrucciones

ASSEMBLY INSTRUCTIONS

1. Determine mounting method.
Downrod Mount (standard or angled ceiling)
Important: lf angle mounting, check to make sure
the ceiling angle is not steeper than 20°.
2. Remove the mounting bracket (A) from the canopy
(B) by loosening the four screws on the top of the
canopy (B). Remove the two non-slotted screws and
save.
3. Install the mounting bracket (A) to the outlet box
(not included) using the two screws provided
with the outlet box. Securely tighten the two
screws.
If using the angle mount, make sure open end of
mounting bracket (A) is installed facing the higher
part of the ceiling.
1
2
Loosen but
do not remove
Remove
and save
3
Outlet box
6
ASSEMBLY INSTRUCTIONS
4. Remove pin and clip from downrod assembly
(E) and save.
5. Insert downrod assembly (E) through canopy
(B), canopy cover (C) and yoke cover (D).
Thread wires from the motor housing (H)
through downrod assembly (E).
A
B
6. Loosen the two set screws from the yoke. Slip
downrod assembly (E) into yoke, aligning holes
in downrod assembly (E) and yoke. Insert the
pin through yoke and downrod assembly (E),
then insert clip into pin until it snaps into place.
Tighten set screws. Slide the yoke cover (D)
down over the fan motor assembly (H).
A
4
Clip
5
B
D
E
6
E
Yoke
Clip
Set screw
7
E
Pin
C
D
Pin
H