Rampage Trailview Tonneau Top Instrucciones De Instalación página 5

Installation Steps
Install Door surround onto the roll cage. Insert door surround knobs. Long
Rear (LR) knob at the rear. Long Front medium (LF) knob at the front and
the Small (SM) knob into the middle hole.
SM Short
LF Medium
12
TIP: Do Not fully tighten m knob at this time.
TIP: Make sure the rubber gasket at the top of the windshield is correctly
sealed against the front surround section. See photo below for proper fit:
14
Fit door surround mount plate on top of door surrounds.
16
Tighten all door surround knobs (SM, LR, LF) into door surround assembly at this time. Repeat steps 12 through 18 on passenger side.
18
Lift roll bar pad as shown for bracket clearance over the roll bar.
LR Long
13
TIP: Make sure the rubber is correctly wrapped around the plastic center
section before tightening with the middle knob.
15
Fit retention strap to driver side door surround mount plate on top of rear
hole in mount plate to hold tube when top is open. Use middle short turn
knob.
17
5
LF Medium
SM Short
LR Long