Lubrication; Changing The Gearbox Oil; Adjusting Controls - NIBBI BRIK 1 Uso Y Mantenimiento

Fig. 16A

LUBRICATION

TYPE OF LUBRICANT
Engine: see engine manual
Motor cultivator: use only ESSO
UNIFARM 15-40 X oil and ESSO
MULTIPURPOSE grease.
1) ENGINE
Each day: check level and top up if
necessary.
Oil replacement: to be carried out
according to intervals and methods set
out by the engine manufacturer.
2) GEARBOX
(capacity 1,7 Kg)
Every 20 hours: check level and top up
if necessary.
Every 500 hours: replace oil
3 ) P O W E R T A K E - O F F F O R
IMPLEMENTS
Before attaching Implements, fill up with
Multipurpose grease
4) ROTARY HOE BOX
(capacity 0,.3 kg.)
Every 20 hours: check level by
unscrewing the cap on the rear cover
of the rotary hoe body. Replace if
necessary.
Every 500 hours: replace oil
GEAR BOX OIL REPLACEMENT
Oil must be replaced when hot, by
unscrewing fillcap A and fillcap B
equipped with an oil dipstick. When oil
is completely drained, replace cap A
and fill up with new oil through hole B
(1,7 Kg). Check level by using dipstick
on cap B.
This operation is to be done with motor
cultivator in horizontal position.
TYRE PRESSURE
Often check that tyre pressure be within
the limits of 1-1,2 bar (Kg/cm
CONTROLS ADJUSTMENT
CLUTCH: Check the idle stroke of the
clutch lever regularly. This should be
approximately 6mm.
- In order to change adjustment, loosen
nut A (Fig. 18A)
- Set stroke to about 5mm by screwing
or unscrewing adjuster B.
- Lock nut A again.
POWER TAKE-OFF CONTROL LEVER:
Periodically check that the idle stroke of
lever 7 be approximately of 6mm. To
change adjustment, loosen nut D (Fig.
18A) and screw or unscrew adjuster C
so that the idle stroke is of 6mm. Then
lock nut D again.
38
Fig 17A
)
2