Frontal Mower Bar Application; Airborne Noise; Handlebar Vibration - NIBBI BRIK 1 Uso Y Mantenimiento

FRONTAL MOWER BAR APPLICATION

Connection to motor cultivator
The mower bar is attached to the motor
cultivator by means of the Quickfit
connection.
Mower height adjustment
When working on bad terrain, it is
necessary to adjust the mower's cut
height in the following way:
- Loosen nut 1.
- Bring the skid pad back to wanted
position 2
- Lock the nut again
- Carry out adjustment on both skid
pads
Blade holder adjustment
- Loosen fixing screws 3.
AIRBORNE NOISE Maximum level of weighted equivalent continuous sound pressure
MOTORCULTIVATOR TYPE
MOTORCULTIVATOR
MOWER
MOTORCULTIVATOR TYPE
ENGINE TYPE
TEST R.P.M.
HANDLEBAR VIBRATION Measurement with weighting according to ISO 5349
MOTORCULTIVATOR TYPE
MOTORCULTIVATOR
MOWER
- Turn the adjustment screws 4.
- Tighten the fixing screws again
N.B.: Excessive friction between the
blade holder and the blade must be
avoided in order to guarantee good
functioning.
Mower blade replacement
- Loosen screws 5.
- Remove blade catch 6
- Slip off the blade
To re-mount the blade carry out the same
operations but in reverse order.
S E R V I C I N G T H E B A R W I T H
C O N N E C T I N G
MECHANISM
Each time the mower is used apply
grease to points 7 and 8.
1 + 1
77,7 dB (A)
83 dB (A)
1 + 1
HONDA G X 160/TECUMSEH
1+1
4,5 m/s
13,4 m/s
40
Fig.21A
INTERMOTOR LGA 225
3050
2
2
R O D - C R A N K
2 + 2
80,8 dB (A)
84,9 dB (A)
2 + 2
2+2
4,5 m/s
2
13,4 m/s
2