T Ools; P Reventive Maintenance; T Roubleshooting; B Elt Tension - SUHNER MACHINING MAX 40 R CO Manual Tecnico

Unscrew: increase the ejection stoke.
Screw: decrease the ejection stroke.
lead: 1.5mm / rotation.
Tighten the locknut (1).
3.3 t
ools
Handle tools and attachments with care, keep
them clean and sharp, and observe the manufac-
turer's instructions on the use of coolants and tool
receivers.
Use the attachments intended for each application. Do
not trim attachments for applications they have not been
designed for.
Always use speeds and feed rates assigned to the attach-
ment and material, and do not exceed the machine's and
the tool's max speed.
Never remove chips with your bare hand, but always use
e.g. hooks, etc.
4. s
ErvicE
4.1 p
reventIve maIntenance
As soon as maintenance or repair work
starts, disconnect the machine from the
power supply, and secure it against acci-
dental reactivation.
The machine is fitted with lifetime lubricated bearings and
is maintenance free.
Check the belt drive for damage every 400 operating
hours.
4.2 t
roubleshootIng
In the event of malfunctions, contact an authorised SUH-
NER aftersales service centre.
4.3 b
elt tensIon
The belt can be tensioned with the adjusting screw. Strike
the end briefly, and measure the natural frequency with a
frequency or belt tension meter.
Voltage for new belt:
To be determined according to the average conditions of
use.
4.4 r
If despite strict observance of the manufacturing and test-
ing method the machine should happen to fail, it must be
repaired by an authorized SUHNER agency.
In all orders to the manufacturer please indicate the com-
ponent serial number of the machine (1).
4.5 w
/M
aintEnancE
In the event of the tool being improperly handled, used
for purposes for which it is not intended and/or of the ser-
vice and maintenance instructions not being observed by
non-authorized persons, no warranty shall be in effect for
damages/consequential damages. Complaints can only
be honored if the machine is returned in the undisassem-
bled condition.
4.6 s
Temperature range: -15°C to +50°C
Max. relative air humidity: 90% at +30°C, 65% at +50°C
4.7 d
This machine consists of materials which can be dis-
posed of in a recycling process.
Before disposal, render the machine unusable.
must be recycled in an environmentally-friendly manner.
epaIr
arranty
torage
/ e
Isposal nvIronmental compatIbIlIty
Do not throw the machine into the garbage collec-
tion.
According to national regulations this machine
33