Ryobi RCS-3535C2 Manual De Utilización página 28

GB GB
F F D D E E
OPERATION
WARNING
Do not allow familiarity with tools to make you careless.
Remember that a careless fraction of a second is
suffi cient to infl ict serious injury.
WARNING
Always wear safety goggles or safety glasses with
side shields when operating this tool. Failure to do
so could result in objects being thrown into your eyes
resulting in possible serious injury.
WARNING
Do not use any attachments or accessories not
recommended by the manufacturer of this tool. The
use of attachments or accessories not recommended
can result in serious personal injury.
APPLICATIONS
You may use this tool for the purposes listed below:
Basic limbing, felling, and woodcutting
Removing buttress roots
FUEL AND REFUELING
HANDLING THE FUEL SAFELY
WARNING
Always shut off engine before fueling. Never add
fuel to a machine with a running or hot engine.
Move at least 9 m. from refueling site before starting
the engine. DO NOT SMOKE! Failure to heed this
warning can result in possible personal injury.
WARNING
Check for fuel leaks. If any are found, correct them
before using the saw to prevent fi re or burn injury.
Always handle fuel with care; it is highly fl ammable.
Always refuel outdoors where there are no sparks and
fl ames. Do not inhale fuel vapour.
Do not let petrol or oil come in contact with skin.
Keep petrol and oil away from the eyes. If petrol or oil
comes in contact with the eyes, wash them immediately
with clean water. If irritation is still present, see a doctor
immediately.
Clean up spilled fuel immediately.
I I P P NL NL S S DK DK N N FIN GR HU FIN GR HU CZ RU CZ RU
English English
MIXING THE FUEL
This product is powered by a 2-stroke engine and
requires pre-mixing petrol and synthetic 2-stroke oil.
Pre-mix unleaded petrol and synthetic 2-stroke engine
oil in a clean container approved for petrol.
This engine is certifi ed to operate on unleaded petrol
intended for motor vehicle use with an octane rating of
87 [(R + M) / 2] or higher.
Do not use any type of pre-mixed petrol/oil from fuel
service stations, This includes the pre-mixed petrol/oil
intended for use in mopeds, motorcycles, etc.
Use synthetic 2-stroke oil only.
Mix 2% oil into the petrol. This is a 50:1 ratio.
Mix the fuel thoroughly and alsoeach time before
refueling.
Mix in small quantities. Do not mix quantities larger
than usable in a 30 day period. A synthetic 2-stroke oil
containing a fuel stabilizer is recommended.
FILLING THE FUEL TANK (Fig. 2)
Clean surface around fuel cap to prevent contamination.
Loosen the fuel cap slowly to release pressure and to
keep fuel from escaping around the cap.
Carefully pour the fuel mixture into the tank. Avoid spillage.
Prior to replacing the fuel cap, clean and inspect the
o-ring.
Immediately replace the fuel cap and hand tighten.
Wipe up any fuel spillage. Move 9 m (30 ft) away from
refueling site before starting engine.
NOTE: It is normal for the engine to emit smoke during
and after the fi rst use.
1 Litre
2 Litres
3 Litres
4 Litres
5 Litres
25 25
RO PL SLO HR TR EST LT RO PL SLO HR TR EST LT
+ 20 ml
+ 40 ml
+ 60 ml
+ 80 ml
+ 100 ml
LV LV SK BG SK BG
=
}
=
= 50:1
=
=