Problems And Solutions - Centrometal SLIM 6 Manual Del Usuario

Problems and solutions

All repairs must be carried out exclusively by a specialised technician, with the
stove completely cold and the electric plug pulled out. Is prohibited from any un-
authorized modifi cation to the device and the replacement of parts with other non-
original. The operations marked in bold type must be carried out by specialised
personnel.
Any inconvenience and solutions
Given that all stoves are tested in their parts handling and work and therefore are delivered in perfect
physical condition and operation, it should be remembered that the transport, unloading, handling, mis-
use or poor maintenance, can be causes of drawbacks.
The main problems may be solved by reading the table below.
If after doing as hereinafter described the problem is not resolved, contact your authorized service center.
PROBLEM
Display off and buttons
are not working
Remote ineffi cient
Failure to ignite
the stove
Smoke comes from the
grill
Hot air fan is not work-
ing
POSSIBLE CAUSE
1. Power failure in the network
2. Switch back off
3. Display defective
4. Fault in the connection of the
display with the card
5. Fuse board interrupted
6. Card defective
1. Too far from the stove
2. No batteries in the remote
3. The remote control is broken
1. Excessive accumulation of ash in
the grate
2. Incorrect ignition procedure
1. Accidental electrical blackout
1. The stove has not yet been
heated
REMEDY
1. Check that the power cord is connected
2. Use the switch back to operate it
3. Unplug the stove from the power outlet for about
one minute and then turn on. If the problem persists,
contact an authorized service center
4. Check that the display and board are properly
connected. Contact your authorized service center
5. Contact an authorized service center
6. Contact an authorized service center
1. Move closer to the stove
2. Check and change the batteries
3. Replace the remote control
1. Clean the grate
2. Repeat the ignition procedure. If the problem per-
sists, contact your authorized service center
1. In case of ignition phase interrupted and momentary
interruption of the fan, can occur slight amount of
smoke
1. Wait until the conclusion of the ignition cycle.
Arrived in temperature, the fan will start automatically.
If the problem persists, contact your authorized service
center.
23