Installation; Preparation For Installation; Transport, Unloading And Installation - Grifo DVEP20 Manual De Instalación, Empleo Y Mantenimiento

GB
Before installing the machine, it is necessary to control the suitability of the place
where it will be located. It being understood that such evaluation must consider the
specific conditions of the location, some important general controls are the following:
 Check the overall dimensions of the machine, leaving a distance of at least 70
cm from any type of fixed obstacle (walls, columns, walkways) to allow the
operator to move without impediments. Check that the foreseen location of the
machine does not interfere with any other machinery.
 Check the suitability of flooring in terms of stability, cleanliness and slope.
 Insure constant, uniform lightning to avoid risks due to shaded areas.
 If the machine is positioned near to transit zones, you must place suitable
barriers around it for protection of accidental bumps with trolleys, trucks etc.
 If it is located on intermediate floors, elevated floors or raised platforms, check
that the maximum carrying capacity is more than the overall weight of the
machine and any other accessories such as lifting equipment etc. always
considering an adequate safety factor.
The machine is supplied already assembled into its operating configuration so the
risks due to movement concern the whole machine.
Transport must be by qualified transporters able to guarantee the correct movement
of the transported materials.
On receipt, control the integrity of the different parts of the machine and check that
the necessary parts for installation are not missing.

4.1 Preparation for installation

4.2 Transport, unloading and installation

Grifo Macchine Enologiche does not accept any responsibility for
damages from transport. The goods are supplied ex-factory.
Document
Manuale vasca e pompa
Flie name
Manuale vasca e pompa

4. INSTALLATION

Year
2016
Page
Revision 15 of 25
0