Starting Up - Grifo DVEP20 Manual De Instalación, Empleo Y Mantenimiento

GB

Following the preliminary controls, you can turn on the machine by activating the start
button placed on the control board. After the engine is started, insert the bunches of
grapes into the hopper that, by means of the auger feed, will be taken to the lower
bin where the rotating shaft separates the grapes from the bunch, destemming them.
The stems exit out through the rear part of the machine while the grapes, passing
through the grate, fall into a bin. There, another auger feed pushes them towards the
must pump where they are transferred to the fermenting vessel.
The dimensions of the output shoot of the stems are determined by safety and
functional needs, in order to favour the expulsion of the stems. In the case of
abnormal accumulation of the stems that could obstruct the output shoot, you must
turn the machine off (disconnect from the mains), and only then, see to freeing the
output shoot.
Check the correct functioning of the controls, in particular the emergency
stop.
In the case when preliminary controls do not have positive
results, you must action the emergency stop, unplug the machine
and warn the department manager.
Document
Manuale vasca e pompa
Flie name
Manuale vasca e pompa

5.2 Starting up

Fig. 4 Controls
Emergency stop
Stop
Start
Year
2016
Page
Revision 18 of 25
0