Wide Panel - Sigma EF-610 DG SUPER Instrucciones

ADJUSTING THE FLASH HEAD
Depress the Bounce "Up and Down" Lock and Release Button, and
adjust the flash head to the desired position.
appears on the LCD panel, when you turn on the flash, and if
◆
this mark blinks, then the flash head is adjusted to an incorrect
position.
ATTACHING AND REMOVING THE FLASH TO AND FROM THE CAMERA
Be sure turn off the Power Switch. Then insert the
Shoe Base into the hot shoe of the camera until it
clicks and locks. ①
When you attach or remove the flash, grasp the
◆
bottom of the flash to prevent damage to the shoe
foot and camera's hot shoe.
If the camera's built-in flash is set in up position,
◆
please close it before you attach the flash unit.
When you remove the flash, slide the flash unit out of
the camera's hot shoe, while pressing the release button. ②
SETTING OF FLASH COVERAGE ANGLE
When you press the ZOOM button
LCD panel display will change and indicate the zoom position in sequence, as follows.
24mm → 28mm → 35mm → 50mm → 70mm → 85mm → 105mm →
Generally, in the TTL mode, the flash will automatically set the zoom position according to the focal
length of your lens.
When you turn on the main switch, the flash will memorize and set the zoom head position to the
◆
last setting used.
If you use a lens wider than the flash head setting, there may be under exposed areas around the
◆
edge of the picture.
Depending on the flash head setting, the flash's Guide Number will be changed.
◆

WIDE PANEL

This flashgun is equipped with a built-in wide panel,
which can provide an ultra wide 17mm angle of
coverage. Slide out the wide panel and catch light
panel and flip it down to cover the flash's head. (Be
careful to slide the panels out smoothly.) Then put the
catch light panel back in its place. The coverage angle
setting of the flash will be set to 17mm automatically.
If the built-in wide panel comes off accidentally, the
◆
button will not function. In this case please
ZOOM
contact the store where the flash was purchased or
a Sigma service station.
LCD PANEL ILLUMINATION
When you press the
stays on longer than 8sec, if you press the
symbol appears. Each time you press the ZOOM button, the
button, the LCD panel will illuminate for about 8 seconds. The illumination
LIGHT
button once again.
LIGHT
Auto)
(
16