Wireless Flash - Sigma EF-610 DG SUPER Instrucciones

WIRELESS FLASH

When you use the "Wireless Flash" mode, you can take pictures with a more three-dimensional effect
by shadow, or you can make natural image by shadow depending on the flash position, without any
extension cord connecting the camera body and the flash. In the case of the EF-610 DG SUPER
SO-ADI, communication between the camera body and the flash will be done by the means of the light
of the flash. In the "Wireless Flash" mode, the camera will calculate the correct exposure automatically.
In this instruction, we call a flash unit, which is attached to the camera body the "Controller", and we
◆
call a flash unit at a remote position the "off-camera flash".
It would be helpful to use a mini-stand when the flash unit is separated from the camera. The
◆
mini-stand has a threaded hole to attach the flash unit to a tripod.
Make sure not to position the flash your picture area.
◆
Place the flash approximately between 0.5m~5m(1.5-5.6ft) range, and camera approximately
◆
1m~5m(3-16ft) range from the subject.
In case of other people using Wireless Flash mode near you, your flash may be influenced by the
◆
other person's flash and your flash may fire. In this circumstance, please set your flash to a
different channel; from that of the other person's flash. Please refer to above settings.
A. USING THE SIGNAL OF BUILT-IN FLASH AS A TRIGGER.
1. Set the camera to the wireless flash mode.
Since the settings vary depending on the camera model, please refer to the instruction manual for
◆
your camera.
2. Set the camera's exposure mode to P,A,S or M.
3. Press the
flash display appears.
4. Set the off-camera flash number to 1 by pressing the
button.
5. Press the button to set the Flash Mode to TTL.
6. Channel information will blink when the
7. Set the channel number (C1 - C4) by pressing
button.
8. Press the
9. Attach the flashgun to the camera body and press the shutter button halfway (the channel number
is recorded to the camera).
10. Remove your flash from the camera and place it at the desired position.
11. Pop-up the built-in flash of your camera, and confirm that it is fully charged.
In wireless flash mode, AF Auxiliary Light will blink to indicate that the flash is fully charged.
◆
12. Adjust the focus of your camera for taking picture.
The EF-610 DG SUPER SO-ADI will fire when the built-in flash fires. The camera's built-in flash is
◆
fired only for control of the EF-610 DG SUPER SO-ADI. The illimunation of the subject is done by
the EF-610 DG SUPER SO-ADI. The camera will control the flash power as a TTL Auto flash, to
obtain the correct exposure.
Depending on the shutter speed, it will be switched automatically to normal flash or high speed sync
◆
flash.
When the camera's exposure mode is set to M, it will be manual wireless flash. After setting the
◆
channel number, the flash power level will blink. Set the desired flash power output by pressing the
or button and then press the
button of the flashgun until the off-camera
button, the indicator will stop blinking.
button is pressed.
or
button to stop the display blinking.
20