Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 35
◆ In wireless photography, setting is possible for each master side and slave side.
◆ If two or more flashguns will be compensated at the same time, please use exposure compensation of
camera.
MULTI FLASH MODE
While the shutter is open, the flash will fire repeatedly. By doing so a series of images of the subject will be
exposed in one frame. A dark background with a bright subject shows more effectively in this mode. It is
possible to set the firing frequency between 1Hz and 100Hz. Up to 90 flashes can be fired continuously.
The maximum number of flashes varies, depending on the flash guide number and firing frequency settings.
(Please refer to table3 on the last page).
1. Set the camera's exposure mode to M mode, and set the F number
2. Press the MODE button until the Multi-flash mode appears
3. Press the SEL button until the flash firing frequency starts to blink.
4. Press the + or - button to set the desired flash frequency value.
5. After pressing the SEL button again, the flash power level will blink.
6. Press the
+ or
7. Press the SEL button again, the number of flashes will blink.
8. Press the
+ or
9. Press the SEL button again, the display will stop blinking.
10. When the ready light of the flash is illuminated, the unit is ready to use.
Note: Please set the shutter speed longer than; Number of Flashes you want ÷ Firing Frequency

WIRELESS FLASH

When this flashgun is used as the controller, it is possible to operate the EF-530 (EF-500) DG SUPER
PA-PTTL at a remote position from the camera body.
◆ Make sure not to position the flash your picture area.
◆ Place the flash approximately between 0.5m-5m (1.5-5.6ft) range, and camera approximately 1m-5m
(3-16ft) range from the subject.
◆ In case of other people using Wireless Flash mode near you, your flash may be influenced by the other
person's flash and your flash may fire. In this circumstance, please set your flash to a different channel;
from that of the other person's flash. Please refer to above settings.
◆ In this instruction, we call a flash unit, which is attached to the camera body the "Controller", and we call
a flash unit at a remote position the "off-camera flash".
When only OFF-CAMERA FLASH is triggered
Controller Setting
1. Attach the flash unit to the camera.
2. Press the MODE button to select the
3. Press SEL button, to make the channel indicator blink on the display.
4. Press + or – button to set the desired channel number.
5. Press the SEL button several times until the display stops blinking.
Off-Camera Flash Setting
6. Press the MODE button to Select the
7. Press SEL button, to make the channel indicator blink, on the display.
8. Press + or – button to choose the same channel number as set
on the controller.
9. Press the SEL button several times until the indicator stops blinking.
10. Place the off-camera flash at the desired position.
11. Check that both flashes are fully charged.
- button to set the desired power level.
- button to set the desired number of flashes.
(Only for P-TTL compatible cameras)
mark.
mark.
16

Publicidad

Tabla de contenido
loading

Tabla de contenido