Wireless Flash; Channel Setting - Sigma EF-630 Manual Del Usuario

in "Hz" (eg.: 10 Hz = Emits light with the frequency of 10
times per second), and the number of flashes in "x".
Set a shutter speed that is slower
3.
than the value of the "number of
flashes" / "flash frequency."
Check the flashgun status with the
4.
Ready light and start shooting.
The number of flashes that can be fired continuously varies
depending on the combination of the flash amount and the
flash frequency. Refer to [Table 2] at the end of this manual.

WIRELESS FLASH

When the flash is used at a location far from the camera, the creative
possibilities are expanded. The EF-630 is controlled remotely
by the camera's built-in flash or a separate Master flash unit.
The flash attached to the camera is called [Master unit], and the

flash used at a distance from the camera is called [Slave unit].
Please set the flash unit between 0.5m~5m (1.6~16ft) from

the subject, and set the camera body between 1m~5m
(1.6~16ft) from the subject.
When setting a Slave unit at the desired position, you can

use mini-stand. This mini-stand has a screw hole for a tripod.
Wireless flash can be used with the camera's integrated flash

(Only cameras that have [Commander mode]). For the
camera settings, refer to the camera's instruction manual.
The EF-630 can also be used in combination with the EF-610 DG

SUPER NA-iTTL. In this case, use the EF-610 DG SUPER as the
Slave unit. When setting EF-610 DG SUPER, refer to the instruction
manual of EF-610 DG SUPER (notation method of the EF-610
DG SUPER slave ID is different. Refer to the following table.)
EF-630 slave ID
EF-610 DG SUPER slave ID
PREPARATION OF WIRELESS FLASH (MASTER UNIT)
SELECTION OF FLASH MODE
Set the desired wireless shooting
mode between [WL
TTL
], and [WL ].
MANUAL MULTI
MASTER FLASH SETTING
It sets whether "Master" is set for the control function only or
for the control function and light emission as a flash.
ON
Control function + Flash
OFF Control function only

CHANNEL SETTING

When another person is performing
wireless flash, setting a different channel
prevents malfunctions (selecting from channels 1 to 4 is possible).
PREPARATION OF WIRELESS FLASH (SLAVE UNIT)
1. Set the flash mode to [WL
2. In the Mode details area, set a
channel that is the same as Master.
3. In the Mode details area, set the
desired flash group (either A, B,
or C) to be selected.
A B
1 2
], [WL
].
SLAVE
C
3
25