INSTALLATION
SAFE WEIGHT
The weight of a TRIDENT safe is related to its size; it is indicated on the label plate
located on the door back plate. It is the customer's responsibility to check that his floor
will be able to stand the floor load.
Moreover, the EN1143-1 specifies that safes which weigh under 1000kgs MUST be fixed.
If you have purchased a TRIDENT 110, 170 or 210 in any of the grades IV, V or VI, the
weight of your safe is below 1000kgs and must therefore be fixed.
SAFE FIXING
All TRIDENT safes are prepared to be based fixed (5 possible fixing holes) or wall fixed
(1 back fixing hole).
Models 110, 170 and 210 are delivered with one anchoring kit included (M16 bolt and
washer).
For all other sizes, a fixing kit is available as an option.
RECOMMENDATIONS PRIOR TO FIXING
We would draw your attention to the fact that only a solid concrete support with high
compression strength (> 250 bar/25MPa) and at least 150 mm thick allows correct
fixing.
Moreover, if the safe is backed against a wall, the clearance between the wall and
the safe must be kept to a minimum.
If the safe is raised on a plinth, it can either be wall fixed (if the walls allows for it) or
screwed on the floor using the extension kit (available as an option) .
FIXING METHOD
Drill the floor/wall with a 24 mm diameter hole, with a minimum of 105mm depth
Position your safe so that the fixing hole matches the floor/wall hole
(If necessary insert the extension kit)
Insert the washer and the bolt and screw up with a dynamometer screw driver until
you reach a torque comprised between 120N.m and 200N.m
7
III, IV, V or VI,
GB
S
F
E
D
I
NL