Maintenance And Storage - YATO YT-30430 Manual Original

GB
and mark out location "B" on the opposite wall (III) or on the target panel attached to that wall.
Bring the product to the other wall without rotating it. Wait until self-levelling is complete and operate the tripod adjustment controls
so that the laser beam is projected directly at the marked-out location "B" (IV).
Rotate the product 180 degrees around the vertical pivot axis on the tripod. Do not adjust the tripod height. Wait until self-levelling
is complete. Mark out location "C" on the wall opposite to the product (V). Location "C" should be directly above or below the
marked-out location "A". Measure distance "d" between locations "A" and "D" (V). It shall not exceed 6 mm. If distance "d" is larger,
have an Authorized Service repair the product.

MAINTENANCE AND STORAGE

Having fi nished your work with the product, wipe it clean with a soft and slightly damp cloth. Next, wipe dry with a soft cloth or
leave to dry. Do not immerse the product in water. Do not clean with solvents, corrosive chemicals, alcohol, gasoline or abrasive
products (e.g. scouring cream). Store the product in a dry, well-ventilated indoor room, away from sunlight. The storage location
should not be accessible to children or anyone not authorized to operate the product. Other storage conditions should be as the
operating conditions. Remove the disposable and rechargeable batteries before prolonged storage.
O R I G I N A L I N S T R U C T I O N S
15