General Maintenance - Cadac SAFARI CHEF 2 6540H0 Manual De Instrucciones

8. Cleaning
BBQ Unit
•
To clean the fat pan, flat pan, and BBQ grid, wash in warm water with a non-abrasive detergent after first wiping off any excess fat left
after cooking.
• To clean the dome, wash in warm water with a non-abrasive detergent.
• Do not use an abrasive cleaner on any part, as this will damage its surface coating.
• These parts are perfectly safe to clean in the dishwasher after removing any excess fat.
Body / Leg Unit
•
This is best cleaned by using a soft damp cloth and a mild non-abrasive detergent. Do not place in a dishwasher as this may allow water
into the valve or burner ports, which will cause the unit to malfunction.
•
When cleaning the body/leg unit the pot stand may need to be removed. This can be done lifting the pot stand out of the locator groove in
the heat shield.

9. General Maintenance

• The onus of maintaining this appliance solely rests on the consumer from date of purchase.
• This appliance does not require scheduled maintenance.
• After prolonged storage, inspect the air holes under the unit and the inlet of the venturi for insects such as spiders, etc which could
affect gas flow. After checking, refit all components into the prescribed position.
Replacing a Blocked Jet:
• Your Safari Chef 2 is fitted with a specific size jet to regulate the correct amount of gas.
• Should the hole in the jet become blocked, this may result in a small flame or no flame at all. Do not attempt to clean the jet with a
pin or other such device
as this may damage the
orifice, which could make
the appliance unsafe.
• To replace the jet: Remove
the fat pan (Fig. 6).
Gently unscrew the burner
assembly (Fig. 7). Remove
the three screws from
the heat shield plate and
remove the heat shield
(Fig. 8), taking care not
to damage the piezo
electrode. The jet can
now be removed using a
suitable spanner (Fig. 9).
Do not use pliers on the
jet as this may damage the
jet, making it unusable
or impossible to remove.
Screw the new jet into the
valve. Do not over-tighten
as this may damage the jet.
• Reverse the above
procedure to re-assemble
the unit.
10. Returning the appliance for repair or service.
• Do not modify the appliance, as this could be dangerous.
• If you cannot rectify a fault by following these instructions, contact your local CADAC distributor for details on how to return the
product for attention.
• Your CADAC Safari Chef 2 is guaranteed by CADAC for a period of 2 years against factory fault.
Fig. 6
Fig. 8
5 5
Jet
GB
Fig. 7
Fig. 9